Verizon Wireless FT2260 - Caller ID Name Display Issue; Adjusting Device Volume; Setting TTY Mode

My Caller ID does not display the name of the incoming caller.
The Home Phone Connect service is no
information will be displayed if the inco
t currently compatible with calling name delivery. Caller name
ming caller's contact information is saved in your home phone
ur
is
al tone and verify that telephone service is
2.
ngle confirmation tone,
vel.
essed an incorrect key. The system will return to the off-hook
n you hear the dial tone.
s the default
y n=1: TTY full mode. Transmit and receive the TTY characters.
y n=2: VCO mode. Receive TTY characters but transmit by speaking into the speaker.
y n=3: HCO mode. Transmit TTY characters but receive by listening to the receiver.
address book.
The volume is too loud.
You can adjust the volume using your telephone connected to the Home Phone Connect device. Fo
volume levels are available, with level 1 being the softest and level 4 the loudest. The default setting
level 4.
1. Take the phone off the hook so you can hear the di
available.
Press # # 1 to adjust the volume.
3. Press keys 1 to 4 to select the desired volume.
4. After selecting the desired volume, press the * key to save it. If you hear a si
you have successfully set the volume le
Note: If you hear a double tone you have pr
state, and you can try adjusting the volume again whe
How to set the TTY mode?
Enter the keys # # 5 6 * n # to set the TTY mode.
y n=0: TTY off mode. The standard voice speaking mode and the listening mode. This i
setting.
Version: V100R001_03 Part Number: 31010DJH
15