Vermont Castings 36CFDV

Questions and Answers

B
buchananchristineAug 19, 2025
Why won't the spark ignitor light the pilot on my Vermont Castings 36CFDV Indoor Fireplace?
- J
  Jaime BoltonAug 19, 2025
  If the spark ignitor on your Vermont Castings Indoor Fireplace won't light the pilot after repeatedly triggering the piezo, there are several potential causes. A wire might be disconnected; open the door and check to ensure the wire is connected to the ignitor. The ignitor itself could be defective; check for a spark at the electrode and pilot. If there's no spark and the electrode wire is properly connected, replace the pilot assembly. There might be no gas or low gas pressure; check the remote/manual shut-off valve. Low pressure can result from bent or restricted lines, or low pressure line pressure, so consult with a plumber or gas supplier. Finally, if you're using Propane/LPG, the tank might be empty; check and refill the tank if necessary.
B
baileykristaAug 27, 2025
What to do if my Vermont Castings 36CFDV pilot won't stay lit?
- J
  Jamie HernandezAug 27, 2025
  If the pilot on your Vermont Castings Indoor Fireplace won't stay lit after carefully following the lighting instructions, it could be due to a defective thermocouple. Ensure the flame impinges on the thermocouple, and clean or adjust the pilot for maximum flame impingement. Also, verify that the thermocouple connection at the gas valve is fully inserted and tight. To test the thermocouple, disconnect it from the valve and use a millivolt meter to measure the output. If the reading is less than 15 mV, replace the pilot assembly. If the thermocouple produces more than 15 mV, the valve may be defective and needs replacement.
K
Kevin PowellSep 3, 2025
How to fix frequent pilot outage problem in Vermont Castings 36CFDV?
- K
  Kurt DavisSep 3, 2025
  Frequent pilot outages in your Vermont Castings Indoor Fireplace could stem from the pilot flame being either too high or too low. This improper flame height can cause the pilot safety to drop out. To resolve this, clean and adjust the pilot flame to ensure maximum flame impingement on the thermocouple.
J
jane23Nov 11, 2025
What to do if my Vermont Castings 36CFDV burner will not ignite?
- V
  Vincent DeanNov 11, 2025
  If the pilot is burning, the valve knob and switch are in the “ON” position, but the burner on your Vermont Castings Indoor Fireplace won't ignite, there are several potential causes. First, the switch, wall switch, remote control, or wiring might be defective. Check the switch and wiring for proper connections. You can use jumper wires across the switch terminals; if the burner ignites, the switch is defective and needs replacement. Repeat this process for the remote control. Alternatively, the pilot flame may be too small and needs adjustment to be closer to the thermopile. Also, the thermopile itself might be defective or malfunctioning; ensure all wire connections are tight and the thermopile is fully inserted into the pilot assembly. A millivolt meter reading below 325 mV indicates th...