1.
3.
2.
4.
· Place the support stand in the wall cavity with the
studs located through the drilled holes.
· Adjust the sliding brackets (A) to come into contact
with the back of the wall and secure.
· Adjust the feet (B) to come into contact with the floor
and secure.
· The 4 mounting points (x2 ‘A’ wall & x2 ‘B’ floor) fit M8
size fasteners, these are not supplied or specified by
Vernacare as building materials vary upon location.
· Fit the wall bracket onto the support stand as shown,
this should locate itself onto the 6 M8 studs.
· Use the M8 nuts and washers provided to firmly
secure the wall bracket to the support stand.
· Please view steps 3 & 4 on the previous page for
instructions on fitting a Compact to the wall bracket.
· Place the template provided in the desired Compact
location.
· Use the identified holes as a drilling template for your
wall fixings.
Wall
Cavity
A
B
To Next Page
Loading...
