PWC – 1000/1010
PureWaterCooler
Copyright 2006 Vertex Water Products
14. Model PWC-1010
The model PWC-1010 has room and cold temperature water dispensed from the
two spigots. Nearly all functions and construction of the PWC-1010 cooler are
the identical to the PWC-1000 (hot and cold) cooler except as follows:
1. There is no heating element in the room temperature holding tank
2. There are no power switches on the back of the cooler
3. The cold power (compressor) turns on as soon as the cooler is plugged in.
4. The indicator lights on the front of the cooler show when there is power
to the compressor (cold power) and when the compressor is on (cooling).
All repair sections of this manual apply to the model PWC-1010 cooler. To
remove and replace the room temperature tank refer to the section covering the
hot tank in this manual (section 5).
To Next Page
Loading...
