Vertex VXR-5000 - TX Unit Access; Control Unit Access; Opening the Repeater Cabinet; Cover Removal and Unit Access

VXR-5000
Cover Removal and Unit Access
The VXR-5000 repeater uses professional
modular card-style unit construction and
mounting. Major units are secured in a mini-
ature
rack-mount cage for easy access and
servicing. Each unit can be removed by un-
screwing
the mounting-tab screws, unplug-
ging the cables to the unit, then sliding the
unit out from the chassis. Plastic guide rails
on the chassis
body ensure positive insertion
and
support the units firmly in place.
Opening the Repeater Cabinet
o To remove the cover, remove the 4 screws
as
shown below and lift the cover off. :Jnit
identification and locations are shown be-
low.
-. .. . ... ~ , Q \oj
(j~.
.61
TX UNIT
CNTL UNIT
RX UNIT
D-SUB UNIT
Control Unit Access
o Remove the two screws from the Control
Unit mounting tabs to loosen it from the
chassis.
CNTL Units 1 & 2
TX Unit Access
o Remove 4 screws from the TX unit mount-
ing tabs to loosen it from the chassis.
o Remove the 10 screws affixing the top
cover,
and lift it off (note the type of screws
used) to expose the
veo Unit.
CAPA U NIT REG UNIT
Unit Loc ation & Identifica tion
1-16