Vertex VXR-5000 - Set up; Penalty-Time; Hi Temp Pwr Red; Hang-Time Audio Sel

from 1 ~ 60 sees. or disabled by pressing
the
SPACE bar.
• Penal ty- Time - this determines the re-
peater "dead" - or penalty-time after the
Time-Out Timer has expired before any
station can access the repeater again.
Timer is adjustable from
10 ~ 360 seconds.
Set Up
The following repeater system operation
can
be programmed according to user re-
quirements from this menu:
• Mode - Use the SPACE bar to toggle be-
tween Simplex or Duplex operation.
• DC RF PWR LVL - When operation shifts
to auxiliary DC
power source, selecting
low
power will result in TX power auto-
matically switching to low
power to ex-
tend operation time under battery power.
VXR-5000
Normal selection retains TX power at the
default
power setting (as set in the align-
mentmode).
• Hi Te mp Pwr Red - This feature automat-
ically
monitors repeater TX power ampli-
fier
temperature, and, if safe operating
temperatures are exceeded, reduces TX
output power (or disables the transmitter)
to
prevent damage from over-heating.
• Al arm Beeper - Enables/disables the
Alarm beep tone as the Time-Out Timer is
about to expire.
• Hang-Time Audio Sel - Determines if
channel
audio (noise) will be heard during
TX hang-time (repeater keyed with carrier
not present). With Quiet selected, receiver
audio will remain squelched, Noise-Out
enables open-channel noise (muted -10
dB) to be heard. Use the SPACE bar to
make a selection.
Repeater System Configuration Setup
Instruction Manual
3-1