Why does my Vertiv Liebert GXT5-1000LVRT2UXL UPS have reduced battery backup time?
If your Vertiv UPS has reduced battery backup time, ensure it's plugged in continuously for at least 24 hours to recharge the batteries. Also, check the load level indicator and reduce the load if the UPS is overloaded. If the batteries are old, consider replacing them. Contact your Vertiv representative or Vertiv Technical Support for a replacement battery kit.
What to do if Vertiv Liebert GXT5-1000LVRT2UXL fails to start?
If your Vertiv UPS fails to start, it might be short-circuited or overloaded. Ensure the UPS is off, disconnect all loads, and check for obstructions in the output receptacles. Also, verify that the connected loads are not defective or shorted internally. Alternatively, the batteries may not be charged or properly connected. Check the internal battery connection and connect it if necessary. If connected, leave the UPS connected to input power for 24 hours to recharge before attempting to start it.
What to do if my Vertiv Liebert GXT5-1000LVRT2UXL fails to start?
If your Vertiv UPS fails to start, it might be due to a short circuit or overload. Turn off the UPS, disconnect all connected devices, and ensure nothing is stuck in the output receptacles. Also, verify that the connected devices are not faulty or shorted internally. Alternatively, the batteries may not be adequately charged or properly connected. Check the internal battery connection and connect it if necessary. If the battery is already connected, allow the UPS to charge for 24 hours by keeping it connected to the input power before attempting to start it again.
Manual contains important safety instructions for installation and maintenance of the UPS and batteries.
Details the features and available GXT5 UPS models and their power ratings.
Explains the basic operating principle and identifies major internal components of the UPS.
Describes the different operating states and modes of the GXT5 UPS, including Normal, Bypass, Battery, ECO, and Maintenance Bypass.
Procedure for unpacking the UPS and checking for shipping damage and included accessories.
Guidelines for preparing the installation environment and site for the UPS.
Instructions for installing the UPS in either a tower or rack configuration.
Step-by-step guide for setting up the UPS in a tower configuration using support bases.
Guidelines and specifications for making hard-wire input and output electrical connections.
Instructions for connecting a REPO switch to ensure emergency shutdown capability.
Overview of configuring the 10-kVA model in a parallel system for redundancy and capacity.
Instructions for safely shutting down the UPS completely, including transfer to bypass.
Details how the REPO switch functions to turn off the UPS in emergency situations.
Essential safety precautions and warnings when working with UPS batteries.
Step-by-step guide for safely replacing internal battery packs in the UPS.
Overview of UPS firmware components and methods for updating firmware.
Steps to update firmware using an RDU101 communication card via network connection.
Procedure to update the DSP firmware using the RDU101 card.
Instructions for updating firmware using a command-line interface (CLI) connection.
Lists and describes displayed UPS faults, their causes, and corrective steps.
Provides a guide to diagnose and resolve common UPS problems and issues.
To Next Page
General