Why does my Vertiv Liebert GXT5-1500LVRT2UXL UPS have reduced battery backup time?
If your Vertiv UPS has reduced battery backup time, ensure it's plugged in continuously for at least 24 hours to recharge the batteries. Also, check the load level indicator and reduce the load if the UPS is overloaded. If the batteries are old, consider replacing them. Contact your Vertiv representative or Vertiv Technical Support for a replacement battery kit.
What to do if Vertiv UPS fails to start?
If your Vertiv UPS fails to start, it might be short-circuited or overloaded. Ensure the UPS is off, disconnect all loads, and check for obstructions in the output receptacles. Also, verify that the connected loads are not defective or shorted internally. Alternatively, the batteries may not be charged or properly connected. Check the internal battery connection and connect it if necessary. If connected, leave the UPS connected to input power for 24 hours to recharge before attempting to start it.
What to do if my Vertiv Liebert GXT5-1500LVRT2UXL UPS fails to start?
If your Vertiv UPS fails to start, it might be due to a short circuit or overload. Turn off the UPS, disconnect all connected devices, and ensure nothing is stuck in the output receptacles. Also, verify that the connected devices are not faulty or shorted internally. Alternatively, the batteries may not be adequately charged or properly connected. Check the internal battery connection and connect it if necessary. If the battery is already connected, allow the UPS to charge for 24 hours by keeping it connected to the input power before attempting to start it again.
Instructions for unpacking the UPS and performing initial checks for damage and completeness.
Guidelines for preparing the installation environment and site for the UPS, including clearances.
Procedures for installing the UPS in either a tower or rack configuration.
Guidelines for making hard-wire input and output electrical connections for the UPS.
Requirements and procedures for configuring and commissioning parallel UPS systems.
Step-by-step guide for powering on the UPS after installation.
Instructions for safely powering down the UPS completely.
How the REPO function works and how to manually trigger an emergency shutdown.
Detailed procedure for replacing the internal battery packs of the UPS.
Provides a guide to identify causes and solutions for common UPS operational issues.
General| Model | GXT5-1500LVRT2UXL |
|---|---|
| Type | Online Double Conversion |
| Topology | Double Conversion |
| Capacity | 1500VA / 1350W |
| Output Frequency | 50/60 Hz ± 0.1% |
| Form Factor | Rack/Tower |
| Rack Height | 2U |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Input Frequency | 40 Hz - 70 Hz |
| Battery Type | Sealed Lead-Acid (SLA) |
| Communication | USB, RS-232 |
| Operating Humidity | 0% to 95% (non-condensing) |
To Next Page
