I.
ELECTRICAL
CONTINUED
NEUTRAL INDICATOR LAMP
• P125X(VNX1l) • P200E(VSX1l)
The illumination
of
the neutral
indicator
light
(®Fig.
3)
is controlled by a
switch
located at the
gear selector box
(@ Fig.
12).
®
Fig.12
NEUTRAL INDICATOR LIGHT SWITCH
CD
If the "NEUTRAL" indicator
light
is faulty, adjust the position
of
the
switch
"G"
by acting as
follows:
If with gear selectorengaged with any gear, the neutral
light
REMAINS
ON:
· Unloose the lock nut
"I"
· Turn clockwise the switch
"G"
until the
indicator
light
is off; in
this
position,
tighten again the locK nut
"'"
If with gear selector in
"N
EUTRAL", the neutral Iight does not light;
· Unloose the lock nut
"I"
· Turn counter-elockwise the switch
"G"
until the
indicator
light
is on; in
this
position, tighten again the
lock
nut
"''',
NOTE:
After every gear cable change, verify that the indicator
light
is correctly illuminated.
Page
10