COMPASS
To enter COMPASS mode (direction measurement), press the
Compass button when in TIME mode. Once in COMPASS
mode, you will see the direction, time, and the direction in
degrees. This compass points to magnetic north and may need
to be adjusted for declination to point to true north.
If the compass is incorrect you must go outside, away from
power lines or other magnetic objects, and calibrate it. There
are two different modes for calibration; DEC (digital correction
mode), and IDLE (auto correction mode)
- Press and hold the Light button.
- DEC: Digital Correction allows you to adjust the compass for
declination.
- Use the Barometer or Altimeter buttons to choose East or
West
- Press Mode to advance.
- Use the Barometer or Altimeter buttons to increase or
decrease the degrees of adjustment. (45° is the max for digital
adjustment)
- Press the Light button to exit.
- Example: If you nd the direction which is measured is not
correct, please use another compass to measure out the northern
direction rst. Then use “12 hour” of the watch to align the
northern direction, press D key to measure compass, if the
arrow point direction is 5° of west (“W”), you should input
“E” (east), then input 5° in eastern direction according to above
operation method. To measure compass after, press A key to
conrm while the arrow will point at northern direction, which
auto. Correction mode as following, but please notice the value
digital correction mode.
Correction Mode.
mode. Or you can press the MODE button to return to TIME.