Vestal Guide - Barometer; Entering Barometer Mode and Display; Adjusting Units and Calibration

14
BAROMETER
To enter BAROMETER mode (air pressure measurement),
press the Barometer button when in TIME mode. Once in
BAROMETER mode, you will see the Weather Forecast icon,
the Temperature, and the Air Pressure.
*NOTE: The Guide is shipped with a Factory default mode
and needs to be adjusted in order to display your air pressure
accurately. For an accurate Altimeter reading, the Air pressure
must be accurate as well.
To adjust the display of the BAROMETER units:
- To alternate between °C - hpa/mb> °C – Inhg> °F - hpa/mb>
°F – Inhg, press and hold the Barometer button until you reach
your preferred combination of Temperature and Air Pressure
units.
To Calibrate the BAROMETER:
There are 3 different modes to calibrate the barometer; TEMP
(Temperature Adjust), FDEF (Factory Default Mode) and
AIRP (Air Pressure Input).
*Note: Set the FDEF mode to NO (off) before you proceed
with other adjustments.
TEMPERATURE ADJUST:
- Press and hold the Light button
- TEMP: This mode will allow you to adjust the temperature.
- Press the Barometer or Altimeter buttons to begin adjusting
the temperature.