10
AUX SEND (Effects Send)
The HDR-V8 has 3 AUX sends and 3 stereo returns. AUX return L is assigned to the master buss
L channel and AUX return R is assigned to R channel. When using a mono output effect processor,
the return signal should be connected to both returns by using a parallel cable or plug.
Increasing the amount of “send” signal increases the effect.
TechTip- AUX return is only active during play back mode. In record mode, all AUX returns are
disconnected.
Operation
1. Press AUX button and select the AUX send number from 1 to 3 (HDR-V8) for the device you
are using. The selected track LED lights up. The bargraph shows the level of each track.
2. Select the track (1-3) to adjust the AUX send level. The selected track LED lights and the
counter shows the level of the selected track with dB. The AUX send level is adjusted from 0dB
to -63.5 dB to off.
3. Adjust the level by using the Jog Dial.
To Next Page
Loading...