To Next PageTo Next PageWhat to do if my VESUVIO VESIN10 display is normal, but there is no heating?
If your VESUVIO Heat Pump's display is normal but there's no heating, it might be because the set temperature is too low. Try setting it to a proper heating temperature. Also, some models have a 3-minute start delay, so waiting patiently might resolve the issue.
Why is my VESUVIO Heat Pump fan running but with insufficient heating?
If the fan in your VESUVIO Heat Pump is running but the heating is insufficient, there might be a couple of reasons: * The evaporator could be blocked; try removing any obstacles. * The air outlet might be blocked; clear any obstructions. * Some models have a 3-minute start delay; wait patiently to see if the heating improves.
How to troubleshoot a VESUVIO VESIN10 that doesn’t run?
If your VESUVIO Heat Pump doesn't run, here are a few things to check: 1. **Power:** Wait until the power recovers if there was an outage. 2. **Power Switch:** Make sure the power switch is turned on. 3. **Fuse:** Check the fuse and replace it if it's burned. 4. **Breaker:** Verify that the breaker is on and turn it on if it's off.
Details operating ranges, conditions, and the advantages of 'Smart' and 'Silence' modes.
Details pre-use checks, control panel operation, and mode selection ('Smart'/'Silence').
Provides guidelines for upright storage, moving, and lifting precautions during transport.
Stresses professional installation, checks for pipe connections, and water pipe length.
General