Need help?Do you have a question about the Vetus DEUTZ DT66 and is the answer not in the manual?
Essential safety instructions and general regulations for engine operation and maintenance.
Procedure for filling the engine with the correct type and amount of oil before initial start.
Procedure for filling the gearbox with the correct type and amount of oil.
Procedures for filling the engine's cooling system with antifreeze and water mixture.
Essential checks before starting, including control lever position and after-repair steps.
Schedule of maintenance tasks based on operating hours or time intervals.
Visual guide to routine maintenance tasks and intervals, often supplied as a label.
Procedure for checking the engine oil level daily before starting and topping up if necessary.
Procedure for checking the coolant level in the header tank when the engine is cold and topping up.
Daily check for dirt in the raw water strainer and instructions for cleaning it.
Keeping the battery clean, checking connections, and greasing posts for optimal performance.
Steps for changing engine oil and filter every 500 operating hours or annually.
Instructions for oiling the filter seal, installing the filter, and refilling the engine with oil.
Procedure for loosening bolts, tensioning, and replacing V-belts for coolant and fuel pumps.
Instructions for replacing the alternator V-belt, including loosening bolts and tensioning.
Steps for removing and installing a new fuel filter, including bleeding the system.
Procedures for inspecting the pump, removing the cover, and sliding out the impeller.
Inspecting the impeller for damage, re-installing it, and replacing the pump cover.
Procedure for draining old gearbox oil and refilling with new oil.
Detailed steps for checking and adjusting valve clearance every 1500 operating hours.
Steps for replacing coolant every 2000 operating hours or two years, including draining.
Procedure for filling the cooling system with the correct antifreeze and water mixture.
Essential torque specifications for various screw connections during maintenance and assembly.
To Next Page
General
