Need help?Do you have a question about the Vetus M Series and is the answer not in the manual?
Details precautions to prevent fire and explosion hazards related to the engine.
Lists actions to prevent cuts, abrasions, and other physical injuries from engine operation.
Provides guidance on how to respond to sudden engine stops or abnormal behavior.
Explains the procedures for conducting an initial engine test run after commissioning.
Details the procedure for starting the engine using the control lever and panel.
Outlines the correct procedure for stopping the engine using the key switch or engine button.
Presents a schedule of maintenance tasks based on operating hours and time intervals.
Details the daily procedure for checking and topping up engine oil.
Guides on checking the coolant level in the header tank and heat exchanger.
Details daily checks and cleaning procedures for the raw water strainer.
Explains how to drain water from the fuel filter and water separator.
Details the procedure for changing engine oil and oil filter every 250 operating hours.
Provides safety regulations and procedures for working with batteries, cables, and connections.
Guides on checking the oil level in Technodrive and ZF-Hurth gearboxes.
Details the procedure for replacing the fuel filter unit every 500 operating hours.
Explains how to check and clean the filter inside the fuel lift pump.
Details the procedure for draining and refilling gearbox oil every 500 operating hours.
Explains how to check and adjust valve clearance on a cold engine for M2, M3, M4.
Explains how to remove the V-belt protection cover and inspect the V-belt for wear.
Guides on inspecting the raw water pump impeller and housing for wear or damage.
Details the procedure for replacing engine coolant every 1000 hours or two years.
Details the procedure for replacing the engine air filter.
Explains how to check the starter motor and alternator for defects and proper function.
Guides on checking and adjusting the engine's maximum and idle speeds.
A table listing common engine faults and their corresponding page numbers for remedies.
Details possible causes and remedies for engine overheating issues.
Provides remedies for low or no engine oil pressure.
Lists torque specifications for various engine screw connections.
Details engine oil specifications, API/ACEA classes, and recommended viscosity.
Lists recommended oil types and quantities for Technodrive and ZF Hurth gearboxes.
Covers coolant preparation, water quality, and protective liquid concentration limits.
To Next Page
General
