INSTALLATION INSTRUCTIONS
1. First of all, ensure that the Hoist is firmly suspended and reliable.
2. The suspension rod load must be greater than the weight of the weight
and hoist.
3. It is strictly prohibited to use the Hoist with overload.
4. It is forbidden to operate with forces other than manpower.
5. Before use, carry out a safety inspection on the Hoist, carry out a
no-load test on the hoist, and reasonably adjust the position of the lower
hook according to the actual requirements.
6. Before lifting, check whether the upper and lower hooks are fastened.
7.When lifting heavy objects, it is strictly forbidden for personnel to do any
work or walk under heavy objects to avoid personal injury or accidents.
Remote Control Note:
1. Make sure that the remote control is within use distance and that there
are no obstructions around it.
2. Product remote control operation, according to the purchase of the
switch, the red light from the wire rope in and out of work.
3. The remote control transmitter power shortage, more than remote
control distance or serious interference, there will be a slow operation or
delay phenomenon, this time should stop the operation, troubleshooting,
and then carry out the operation.
4. Do not put the remote control in contact with water or humidity. If there is
signal interference, the remote control will cause leakage or damage to the
internal circuit. Signal interference will cause the consequences of remote
control.
5. Do not use sharp objects to press the remote control to avoid causing
damage to equipment.
6. If not used for a long time, please remove the battery.
The steel wire rope instruction:
1. The operator should understand the situation of the product and be
familiar with the performance of the product.
To Next Page
Loading...
