make any connections to the carburetor, fuel lines, or thin, sheet metal
parts. The below instructions are for a negative ground system (most
common). If your vehicle is a positive ground system (very uncommon),
follow the below instructions in reverse order.
1.) Connect the positive (red) eyelet terminal connector to the positive
(POS,P,+) battery terminal.
2.) Connect the negative (black) eyelet terminal connector to the negative
(NEG,N,-) battery terminal.
3.) Connect the battery charger into a suitable electrical outlet. Do not face
the battery when making this connection.
4.) When disconnecting, disconnect in the reverse sequence, removing the
negative first (or positive first for positive ground systems).
Begin Charging.
1.) Verify the voltage and chemistry of the battery.
2.) Confirm that you have connected the battery clamps or eyelet terminal
connectors properly and the AC power plug is plugged into an electrical
outlet.
3.) [First time use] The charger will begin in Standby mode, and pause will
be circled by blue . In Standby, the charger is not providing any power.
4.) Press the key battery type to select batteries,secondly press the key
Voltage,thirdly press the key Current.
5.) Press the key Start and it will be lined by blue,secondly the battery will
be detected.If the battery is normal,no battery indicator will lose and the
charger will work normally, or reversly.
6.) The charger can now be left connected to the battery at all times to
provide maintenance charging.
Auto-Memory: The charger has built in auto-memory and will return to the
last charge mode when connected. Select suitable mode and press the key
Start and then the charger will save new working mode.
Caution:Professional Mode can’t Auto-Memory.
To Next Page
Loading...
