product, contact VEVOR Support (email and phone number above) or write
to: The VEVOR Company, at 30339 Diamond Parkway, #102, Glenwillow,
OH 44139
When the machine cannot be charged during use, the product
display will display the fault code, please refer to the following fault
code number description table, corresponding to the fault number to
eliminate the phenomenon of non-charging caused by misoperation.
The battery output electrode is reversed
The charger output is shorted
The temperature inside the machine is too high
The output charging mode is selected incorrectly
Output voltage over voltage
Output current over current
1.Battery charging cable *1
2.Plug the power cord at the end of the figure-eight tail *1
3.Copper wire terminals*2
4.Product body * 1
5.Instructions *1
To Next Page
Loading...
