Charging Modes.
The GS280C has fifteen (15) modes: Standby, CHARGING(6VAGM,12V
AGM,24V AGM, 12V Lithium,24V Lithium,12V
LiFePO4,24VLiFePO4),Maintain(6VAGM,12V AGM,24V
AGM),Desulfation(6VAGM,12V AGM), and Force mode(6VAGM,12V
AGM,24V AGM). When Force mode selected,you can charge by selecting
different currents with different Voltages .Please select battery types after
open the switch.These modes are advanced charging modes that require
your full attention before selecting. It is important to understand the
differences and purpose of each charge mode. Do not operate the charger
until you confirm the appropriate charge mode for your battery. Below is a
brief description:
Explanation (Peak Voltage Measured At 25°C, Amperage Rating Is Bulk
Amperage When Above 0°C)
In Standby mode, the charger is not charging or providing any power to the battery.
Energy Save is activated during this mode, drawing microscopic power from the
electrical outlet. Canbus is enabled in Standby mode. When in Standby, the LCD will
illuminate.
For charging 6-volt Lead acid batteries. When selected, the 6V will be lined
by blue.
7.3V | 5A | Up To 110AH Batteries, 7.3V | 10A | Up To 230AH Batteries.
For charging 12-volt Lead acid batteries. When selected, the 12V will be
lined by blue.
14.6V | 5A | Up To 110AH Batteries, 14.6V | 10A | Up To 230AH
Batteries,14.6V | 20A | Up To 300AH Batteries
For charging 24 -volt Lead acid batteries. When selected, the 24V
will be lined by blue .
29.2V | 5A | Up To 110AH Batteries,29.2V | 10A | Up To 230AH Batteries
For 12-volt LiFePo4 batteries. When selected, the 12V will be lined by
blue.
14.6V | 5A | Up To 110AH Batteries,14.6V | 10A | Up To 230AH
Batteries,14.6V | 20A | Up To 300AH Batteries
For 24-volt LiFePo4 batteries, the 12V will be lined by blue.
29.2V | 5A | Up To 110AH Batteries,29.2V | 10A | Up To 230AH Batteries
For 12V Lithium charging batteries. When selected, the 12V will be
lined by blue.
12.6V | 5A | Up To 110AH Batteries,12.6V | 10A | Up To 230AH
Batteries,12.6V | 20A | Up To 300AH Batteries