TROUBLESHOOTING
Check control unit is connect to the mains power
supply and that the unit is switched on.
-Check main power to the control unit and that the plug
is switched.
-Check mattress air supply connector is connected to
the pump unit correctly.
-Check CPR connector is connected properly.Under
the mattress cover
-Check a lT&“L connectors are connected to the air
tubes.
-Check the connector tubes for kinks, crimps or
damage.
Patient's body is
sagging in the
middle/bottoming out
Increase the value of the comfort the setting. Wait a
couple of minutes so pressure can stabilize before
making another change.
Control lock up or
“freeze"
Turn the control unit off and unplug the pump. Wait a
few minutes and plug the control unit back in. Turn on
the control unit.
To Next Page
Loading...
