SAFETY WARNINGS AND PRECAUTIONS
1. Voltage, frequency and the wiring style should be consistent with the
motor nameplate, power supply voltage should be maintained at plus or
minus 5% of the rated operating range.
2. No more than 1000 meters above sea level.
3. Ambient air temperature not exceeding 40
℃
.
4. The motor must have a good grounding device
5. Before option must measure 500-volt megohm table winding insulation
resistance to ground, and its value should be more than 0.2 megohm, or to
be dried.
6. Before starting pull action shaft, it should be flexible rotation, no friction
and collisions, running should be smooth and lightly, without stagnation
and the noise, if found the strange noise, overheating, burning smell,
smoke or slow speed of the phenomenon, should immediately turn off
power, shutdown inspection, repair it.
7. The surrounding environment should keep clean and dry and well
ventilated.
8. Check whether the motor fastening is fasten.
9. Motor routine maintenance: Electrical outlet box part of the electrical
contacts should be kept clean and good contacts, whether the motor air
inlet plug, so as not to affect the motor life. Regular maintenance should
be a half a year, check the motor remove dust and oil, grease and
abrasion.
10. The motor running check: When motor is operated it should always
be paid attention to whether the load data in current with requirement,
whether the bearing has phenomena of heat and leakage, if found
abnormal or sound, should be stopped immediately for inspection. Until
fault is identified, do not do Starting test.
GENERAL INFORMATION
Pool Pump Motor are all fully factory tested and inspected before
shipping. Damage during shipment and storage can occur. Motors not
correctly matched to the power supply and/or the load will not operate
To Next Page
Loading...
