Lacquer / lacquer sanding sealer
Material flash point must be 55°C or higher.
1. Preparing the Coating Material
Before spraying, the material being used may need to be thinned with
the proper solvent as specified by the material manufacturer.
Never exceed the thinning advice given by the coating
manufacturer.
Note: Material to be sprayed should always be strained to remove any
impurities in the paint which may enter and clog the system. Impurities
in the paint will give poor performance and a poor finish.
Thinning chart:
Hold the test cup up and measure the time in seconds until the liquid empties
out. This time is called "Run out Time in Seconds".
Note: stir the spraying material thoroughly before measuring and fill
into the canister.
To Next Page
Loading...
