Why are the fast connections on my VEVOR Lifting Systems getting harder to connect?
The hydraulic system may be under increasing pressure. To prevent this, after the frame reaches the ground, hold down the drop button on the remote control for a few seconds to get as much hydraulic fluid as possible back to the tank. If the pressure accumulation is too high to allow for quick connection, please contact the dealer.
What to do if my VEVOR JT-5000 Lifting Systems can't lift?
If your VEVOR Lifting Systems can't lift, ensure that the hydraulic hose is not clamped or leaking, that there is sufficient hydraulic oil in the tank, and that the power supply unit has the appropriate power supply. Also, check the oil pump exhaust.
What to do if my VEVOR JT-5000 Lifting Systems is not using the remote control also slowly drops down?
Ensure that the easy lift jack is in the locked position. If it's not locked, the hydraulic oil will leak slowly, lowering the frame.
What to do if my VEVOR JT-5000 has hydraulic oil pollution?
Replace the polluted hydraulic oil with the specified hydraulic oil.
What to do if my VEVOR JT-5000 Lifting Systems can't drop?
Ensure that there is a weight on the frame.
Why the gas pump on my VEVOR JT-5000 cannot maintain pressure?
You can check them using standard valve tools. Do not make the spool too tight.
What to do if my VEVOR Lifting Systems is stuck at the highest point with no load?
Requires weight down from a fully raised position. Reference to no load at the top for help.
Details on using the mat block for lifting vehicles.
Guides on positioning the lift jack frames relative to the vehicle.
Steps for positioning the lifting jack framework correctly.
Step-by-step guide for operating the lifting platform.
General| Model | JT-5000 |
|---|---|
| Material | Steel |
| Power Source | Electric |
| Operation Type | Remote Control |
| Type | Electric Hoist |
| Rated Line Pull | 5000 lbs |
| Voltage | 110V |
To Next Page
