- 4 -
INSTALLATION STEPS FOR TYPE A(SKU1~SKU3)
STEP 01 select the dimension
The sizes of the type A curb ramps are listed in parameter table. The load
limit is 15 tons. Please choose the size that matches the ramp .
STEP 02 Align ramp sections
Facing your house, ensure that the ramp sections are in the correct
order,paying attention to the angle of the ends.
STEP 03 Flip ramp into street
Turn the ramp sections over into the street so that they are flat side down.
If you have additional center sections, the hardware from one side of that
ramp must be removed. To remove excess hardware from one side,
strike underneath the bolt head with the claw portion of your hammer and
extract.
To Next Page
Loading...
