an after sales technician using the proper tools so as to avoid any
accidents.
The installer must ensure that the correct electrical connection has been
made and that it complies with safety regulations
The cable must not be bent or compressed
The cable must be checked regularly and only replaced by a properly
qualified person.
Electric ceramic stove failure:
No heating for 2 minutes after the gear is selected, an "E4" fault will be
displayed.
Customer Service Email: CustomerService@vevor.com
(Please send relevant videos and pictures to our email address, and attach
your Amazon order number. After confirming the problem, we will definitely
give you a satisfactory solution.)
Diagram of the radiant hob
Schematic diagram of the control panel
Instructions for Use
Operating the device
Place suitable cookware onto the cooker plate,The operation of both zones
is the same.
Caution! Make no hot pots or pans on the keypad!
Stand-By-Modus
Press the On / Off button. You will hear a beep and see flashing lines on
the display at the upper and lower plate. If you have not selected a
program within about 2 minutes, the unit will return to standby.
To Next Page
Loading...
