PLUG.
WARNING! It is the user's responsibility to read, understand and comply
with the following electrical instructions.
You must ensure the risk of electric shock is minimized by the installation
of appropriate safety devices. An RCCB (Residual Current Circuit Breaker)
should be incorporated in the main distribution board. We also recommend
that an RCD (Residual Current Device) is used with all electrical products,
particularly portable equipment which is plugged into an electrical supply
not protected by an RCCB.
You must also read and understand the following instructions concerning
electrical safety.
3.1.1 The Electricity At Work Act 1989 requires all portable electrical
appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT) at least once a year.
3.1.2. The Health & Safety at Work Act 1974 makes owners of electrical
appliances responsible for the safe condition of the appliance and the
safety of the appliance operator. If in any doubt about electrical safety,
contact a qualified electrician.
3.1.3. You must ensure that you:
√ Inspect the transformer plug, cable, and plug for wear and damage to
ensure items are safe before connecting to the mains power supply. If any
parts are worn or damaged DO NOT use the transformer and immediately
replace it or contact a qualified electrician.
√ Ensure cables are always protected against short circuit and overload.
√ Important: Check that the voltage marked on the transformer plug is the
same as the power supply to be used.
√ Uncoil the lead from the transformer before use.
× DO NOT attempt to pull the transformer plug from the mains socket by
the lead.
× DO NOT use any other type of transformer with the cabinet.
× DO NOT try to open or dis-assemble the transformer plug or charging
base.
× DO NOT use the transformer plug to power any other electrical item.
× DO NOT get the transformer wet, or use in wet, damp conditions (for
To Next Page
Loading...
