indoor use only).
WARNING! NEVER substitute the standard 2 pin plug, or any other type of
plug, for the transformer plug.
3.2 GENERAL SAFETY
WARNING! Ensure Health & Safety, government and local authority
regulations relating to the use of shot blasting are adhered to when using
this equipment. Familiarize yourself with the applications, limitations and
potential hazards peculiar to the cabinet.
WARNING! Disconnect the cabinet from the mains power and air supply
before attempting to change accessories or carry out any servicing or
maintenance.
√ Maintain the cabinet in good condition. Replace or repair damaged
parts. Use genuine parts only. Unauthorized parts may be dangerous and
will invalidate the warranty.
√ Locate cabinet in a suitable work area and keep area clean, tidy and
free from unrelated materials. Ensure there is adequate lighting.
√ Use only dry abrasives such as proprietary brands of glass beads,
silicon carbide, aluminum oxide and silica sand. Never use fluids or mix
fluids with another media in the unit.
WARNING! Always wear approved eye or face and ear protection when
operating the cabinet.
√ Keep the units top lid closed and secured when in use.
WARNING! Ensure correct air pressure is maintained and not exceeded.
(Max 80psi – 5,5bar).
√ Always keep the blast nozzle directed at the work piece. Never operate
the gun outside the unit and always use the cabinet with the top lid closed.
√ Regularly check that the exhaust vent at the back of the cabinet is clear
and not blocked and that there is sufficient space between the cabinet and
any wall.
√ Ensure the floor is clean and free from blasting media spillage. Wear
non-slip shoes.
√ Remove ill-fitting clothing. Remove ties, watches, rings, and other loose
jewelry and contain and/or tie back long hair.
To Next Page
Loading...
