3.The hose assembly attaches to the PCP airgun at the other end via a
Foster-fit.An additional adapter/ connector may be required [fig4] due to
the many differenttypes of filler-fittings used across PCP airgun makes
(refer specific PCP manufacturer).
Note: A thread-to-Foster adapter is included in the accessory pack [fig 5].
POWERING UP THE UNIT
The Portable Compressor can be powered from either mains electricity (AC power) or
from a 12v car battery (DC power). When powered by battery, ensure the car
engine is running.
wrong: DO NOT run the air compressor without the cooling fan in operation.
To Next Page
Loading...
