Important safety information
Please observe the following safety precautions when using your OSSC.
Use the correct power supply – OSSC is designed to run with a 5 volt, 2.1 x 5.5mm positive tip
power supply unit (PSU) supplying at least 1 amp of current. Please ensure your power supply
meets these requirements. Never connect a power supply that supplies more than 5 volts. Doing so
can damage the OSSC.
Turn off the power before connecting/disconnecting equipment – To prevent damage of the
OSSCs integrated circuits, always turn off the power before connecting to a display or a device.
Do not expose to moisture – Droplets of moisture may contact the PCB and cause a short circuit.
Never submerge the unit in water.
Keep away from fire or high heat sources – OSSC is not flammable but high temperatures, such
as those from a fire or electric heater may melt the plastic casing.
Please supervise children – OSSC is not a toy and is not designed for use by children. Please
supervise children if they use the OSSC.
Beware of using the OSSCs deinterlacer on sources that display static graphics or text for a
long period of time – OSSCs deinterlacer produces a constant flickering effect. This can cause
image retention/burn in to occur faster than normal. See page 8 for more information.
To Next Page
Loading...