Vibe 7 Series - Low Level Input (Stereo 4); High Level Input (Stereo 4); Ch 3;4 Remote Level Port; Speaker Terminals (Stereo 4)

18. Low level input
For connection to any source (headunit) with a low level output. This is your RCA output from the
source.
19. High level input
For connection to the speaker output of your source (head unit). This is to be used if the source (head-
unit) does not have a low level output.
20. CH 3/4 Remote level control port
For connection to the supplied remote level control for channels 3 and 4.
21. Speaker terminals
Used to connect speaker cables to the amplier. See the wiring conguration section for more details.
22. Power / protect LED
If the amplier is operating normally, the GREEN LED will illuminate.
If the amplier is in protection mode the RED LED will illuminate.
23. Fuses
Replace with only the same value ATC fuse : 3 x 25A
24. Power terminals
Used to connect DC power to the amplier. See the power connections section for more details
10
CVEN Stereo 4 Terminals And Connections