Vibe 7 Series - Channels 3;4 HPF Select Switch; Channels 3;4 HPF Multiplier; Channels 3;4 HPF Control; Channels 1;2 Gain Control

8. CH 3/4 High Pass Filter (HPF) select switch
This switch is used to turn the HPF on or off for channels 3 and 4.
9. CH 3/4 High Pass Filter (HPF) frequency multiplier switch
This switch is used to select the frequency multiplier for the high pass lter for channels 3 and 4.
x 1 and x10 settings are selectable.
10. CH 3/4 High Pass Filter (HPF) control
This control is used to set the crossover frequency for channels 3 and 4 when HPF is
selected. The frequency is adjustable between 40Hz and 600Hz or 400Hz and 6000Hz depending on
the position of the multiplier switch.
11. CH 1/2 Gain control
This control is used to match the input signal of the source to the amplier for channels 1 and 2. See
the setup section for more details.
12. CH 1/2 Low Pass Filter (LPF)
This control is used to set the crossover frequency for the amplier when LPF is
selected. The frequency is adjustable between 40Hz and 600Hz or 400Hz and 6000Hz depending on
the position of the multiplier switch.
13. CH 1/2 Low Pass Filter (LPF) frequency multiplier switch
This switch is used to select the frequency multiplier for the low pass lter for channels 1 and 2.
x 1 and x10 settings are selectable.
14. CH 1/2 Low Pass Filter (LPF) select switch
This switch is used to turn the LPF on or off for channels 1 and 2.
15. CH 1/2 High Pass Filter (HPF) select switch
This switch is used to turn the HPF on or off for channels 1 and 2.
16. CH 1/2 High Pass Filter (HPF) frequency multiplier switch
This switch is used to select the frequency multiplier for the high pass lter for channels 1 and 2.
x 1 and x10 settings are selectable.
17. CH 1/2 High Pass Filter (HPF)
This control is used to set the crossover frequency for channels 1 and 2 when HPF is
selected. The frequency is adjustable between 40Hz and 600Hz or 400Hz and 6000Hz depending on
the position of the multiplier switch.
9
CVEN Stereo 4 Terminals And Connections