Vibe 7 Series - CVEN Stereo 2 Terminals and Connections; Gain Control Adjustment; Bass Boost Control; Bass Boost Frequency

1. Gain control
This control is used to match the input signal of the source to the amplier. See the setup section for
more details.
2. Bass boost control
This control is used to add bass boost to the amplier and is variable between 0dB and +12dB
3. Bass boost frequency control
This control is used to select the frequency for the bass boost, it is variable between 30Hz and 80Hz.
4. High Pass Filter (HPF) frequency multiplier switch
This switch is used to select the frequency multiplier for the high pass lter. x 1 and x10 settings are
selectable.
5. High Pass Filter (HPF)
This control is used to set the crossover frequency for the amplier when HPF is
selected. The frequency is adjustable between 5Hz and 400Hz or 50Hz and 4000Hz depending on
the position of the multiplier switch.
6. Low Pass Filter (LPF) frequency multiplier switch
This switch is used to select the frequency multiplier for the low pass lter. x 1 and x10 settings are
selectable.
7. Low Pass Filter (LPF)
This control is used to set the crossover frequency for the amplier when LPF is
selected. The frequency is adjustable between 30Hz and 400Hz or 300Hz and 4000Hz depending on
the position of the multiplier switch.
1 2 3 4 5 6 7 8
11 12 13 14 15
9 1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
10 11 12 13 1410
16 17 15 16 17 18 19 20 21 22 23
18 19 20 21 22 23 24 24 25 26 27
10 1211 13 1414
28 29 30
6
CVEN Stereo 2 Terminals And Connections