Specification BlackBox stereo 2
RMS Power @ 13.8v DC
Power @ 4 Ohms stereo 2 x 100 WRMS
Power @ 2 Ohms stereo 2 x 125 WRMS
Power @ 4 Ohms bridged 1 x 250 WRMS
Minimum speaker impendence 2 Ohm stereo / 4 Ohm bridged
THD Distortion 0.1%
IMD Distortion 0.1%
Frequency Response 7Hz - 38 KHz
Input Sensitivity 250 mV - 5V
Input Impendence 15K
Signal to Noise Ratio 96 dB
Channel Separation -61 dB
Crossover Network
Low pass filter 30 Hz – 300 Hz
Bass Boost 0 dB - +24 Db
High pass filter 50 Hz – 1KHz
Fuse rating 15A x 2
Size length x width x height 348mm x 224mm x 57 mm
BlackBox stereo 4
4 x 100 WRMS
4 x 125 WRMS
2 x 250 WRMS
2 Ohm stereo / 4 Ohm bridged
0.1%
0.1%
5Hz - 43 KHz
250 mV - 5V
15K
88 dB
-57 dB
30 Hz – 300 Hz
0 dB - +24 Db
50 Hz – 1KHz
30A x 2
448mm x 224mm x 57 mm
Specification BlackBox bass 1
RMS power @ 13.8 vDC
Power @ 4 ohms 1 x 650 WRMS
Power @ 2 Ohms 1 x 1000 WRMS
Power @ 1 Ohm 1 x 1250 WRMS
Minimum speaker impedance 1 ohm
THD Distortion 0.8 %
IMD Distortion 0.8 %
Input Sensitivity 250 mv - 5V
Input Impedance 15 K
Signal to Noise Ratio 95 dB
Crossover Network
Low Pass Filter 40 Hz - 250 Hz
Bass Boost 0 dB -+18 dB
Subsonic Filter 15 Hz - 50 Hz
Fuse Rating 35 amp x 4
Size length x width x height 478 mm x 224mm x 57mm
BlackBox stereo amplifiers
BlackBox bass amplifier
To Next Page
Loading...
