What to do if fault light is continuously on Vibration Research VR9500 Controller?
If the fault light is continuously on while the status light is continuously off in your Vibration Research Controller, try turning the power off and then back on to reset the unit.
How to fix power light if it fails to illuminate on Vibration Research Controller?
If the power light on your Vibration Research Controller fails to illuminate, verify that the power cord is plugged into a live outlet and the power switch is on.
What to do if network port is not linked on Vibration Research VR9500?
If the network port is not linked (NETWORK LED is red solid) on your Vibration Research Controller, check if the cable is disconnected or faulty.
Connect VR9500 to power, computer, and peripherals for initial setup.
Set up PC network card and IP address to communicate with VR9500.
Guide to defining parameters for a Sine vibration test.
Configure test profile breakpoints, duration, and sweep rate.
Define feedback parameters and tolerance/abort limits for Sine tests.
Guide to defining parameters for a Random vibration test.
Configure test table breakpoints, duration, and limits for Random tests.
Guide to defining parameters for a Shock vibration test.
Define pulse shape, duration, and limits for Shock tests.
Guide to setting up a test to replicate recorded field data.
Resolve issues where VR I/O box is not communicating with host computer.
Troubleshoot VR I/O box failing to respond to requests.
General| Input Voltage | ±10 V |
|---|---|
| Resolution | 24-bit |
| Input Voltage Range | ±10 V |
| Output Voltage Range | ±10 V |
| Interface | USB, Ethernet |
| Maximum Output | ±10 V |
| Dynamic Range | 120 dB |
| Control Algorithms | Shock |
| Operating System Compatibility | Windows 7, 8, 10 (32-bit and 64-bit) |
To Next Page
