Victor 4000 User Manual

Warning
Thank you for purchasing our VICTOR4000 Double Clamp Digital Phase Meter, in order to
better use of this product, be sure to:
---- To read this user manual carefully.
---- Comply strictly with safety rules and precautions set out in this manual.
u Pay special attention to safety under any circumstances while using the
instrument.
u Take note of the label text and symbols on the panel and back of the
instrument.
u Make sure that the instrument and accessories are intact and there’s no
damage to the instrument or test wire insulation layer, or bare and broken wires before using
it.
u Make sure that the function switch has been set up within the appropriate
range before the test.
u Can not be used to test voltage higher than 500V.
u It’s prohibited to use the instrument without the rear cover and battery cover
in place.
u Make sure that the connection plug is closely inserted in the socket.
u Don’t use or replace batteries if the instrument is wet.
u Test is prohibited in flammable and dangerous places.
u The test line could only be pulled out from the instrument after being removed
from the measured wire; don’t touch the plug jack by hand to avoid an electric shock.
u Do not use the instrument in strong electromagnetic environment in order to
prevent the equipment from work improperly.
u Stop using the meter in case of metal exposure due to a broken chassis or
fractured test line.
u Do not place or keep the device in hot and humid environment, or places of
dew condensation or long time direct sunshine.
u The instrument and current clamp must be maintained regularly to keep
clean, corrosive solution and coarse materials can't be used to clean the clamp.
u Keep the current clamp from any impact, especially the clamp joints.
u The instrument has an automatic shutdown function.
u Remove or replace the battery if the instrument is not used for a long time,
and take note of the battery polarity.
u Take note of the measurement range and application environment required
for the instrument.
u The operation, demolition, calibration and maintenance of the instrument
must be carried out by qualified personnel authorized to do so.
u The meter should be stopped from being used immediately and sealed if
danger is brought up in case of continued use; only a competent body can be authorized to
deal with it.
u “ ” in the manual is the safety warning sign, the contents of this manual
must be followed for safe operation.
u “ ” and other safety signs, the contents of this manual must be followed
for safe operation.
A． Introduction
The VICTOR4000 Double Clamp Digital Phase Meter is a well-developed multi-functional

Victor 4000 Specifications

General

Brand	Victor
Model	4000
Category	Measuring Instruments
Language	English