5. SLIDER SWITCH FEATURES
1. OFF NP P Printer Selects Switch
OFF The calculator is turned OFF.
NP (Non-print) Printer is activated only when feed key or non-add/date key is
pressed.
PRINT Printer is activated.
2. ↓ 5/4 ↑ Rounding Switch
↓ All calculations will be rounded down.
5/4 Final result is rounded up if the 1
st
digit not to be printed is 5 or more
and rounded down if the 1
st
digit not to be printed is 4 or less.
↑ All calculations will be rounded up.
3. A 0 2 3 4 F Decimal Point Selector
A Monetary Add Mode: At this setting, amounts entered are assumed to be
monetary. The calculator automatically supplies a decimal point to the left
of the last two digits entered. Use this setting to add, subtract, multiply,
and divide decimals.
0,2,3,4 Fixed Decimal Point Mode: These settings specify the number of digits to
the right of the decimal point that are shown in the result.
F Floating Decimal Point Mode: This setting specifies that all digits of the
result are shown, up to a maximum of 10 in the 10 Digit Big Print mode,
and 12 in the 12 Digit Regular Print mode. If the result exceeds these
capacities, excess digits to the right of the decimal point are dropped. No
rounding takes place.
4. 10 / 12 Digit Selector
10 Sets the calculator to 10 Digit Mode with larger print.
12 Sets the calculator to 12 Digit Mode with normal size print.
5. Grand Total Switch
• Calculation without Grand Total
GT Any total taken with T key is automatically accumulated to Grand Total.
The accumulated grand total can be recalled by pressing GT key.
To Next Page
Loading...
Need help?
General
