: single - single temp. - double temp.
( UP/DOWN to switch).
: -300 - 0 - +300 sec/month
( UP/DOWN to switch).
: active - not active
( UP/DOWN to switch).
: 0 - 1 - 2 - 3 ( UP/DOWN to switch).
: 0 - 1 - 2 - 3 ( UP/DOWN to switch).
In "
machine ready" state you can go direct to the set-
tings below instead of surfing the menu.
Pres
s + to go directly to the Setting Point
menu (this will be bars or °C/°F depend on the status
view you were).
press UP or DOWN to move up and down
the working Point.
Press to confirm and pass to the next step.
The display can also show you the pressure or tempera-
ture status of the boiler; to pass from one to the other,
press the key on the display.
In the case of pressure, the reading will be shown in bar,
while for temperature, it will be in degrees Celsius (°C)
or Fahrenheit (°F). The display setting for the tempera-
ture can be chosen from the setpoint setting page. In
fact, when choosing the temperature mode, the setpoint
will be shown in degrees Celsius or Fahrenheit accord-
ing to the chosen measurement.
This
allows to rotate into the three working modes/sta-
tuses.
Press for 3 sec to switch
the machine status.
To Next Page
Loading...
Need help?
General
