47
ENGLISH
4.3 LED SWITCH ON 4.5 STEAM FLOW
ADJUSTMENT
4.4 BUTTONS KEY
Selection
Configuration
• Switch off the disconnector and set the main
switch "B" to “I”.
Use the lever to increase/reduce the flow of
steam injected into the milk, as illustrated in the
following figure.
Fig. 16
NOTE: Before using the steam wand, always
bleed out any condensation for at least
2 seconds or according to the manu-
facturer’s instructions.
Fig. 15
In case the auto diagnosis indicates error or
malfunction, call the assistance centre; the
operator MUST NOT intervene.
WARNING
HEATING
MACHINE READY
NOTE: Once the auto diagnosis has been com-
pleted all the keys are activated.
Automatic On / Off PROGRAMMED
The machine will SWITCH ON at the first pro-
grammed switch-on time (see the section enti-
tled "PROGRAMMING" and paragraph
"PROGRAMMING ON - OFF").
The control unit will perform an auto diagnosis
of all functions and all of the selection keys will
light up. Once the diagnosis is complete, the
display will read as follows:
with the date and time. Once the temperature of
110°C has been the word “Heating” will disap-
pear to be replaced by:
The machine will SWITCH OFF at the first time
set for stop-ping the coffee maker (see chapter
on "PROGRAMMING" and paragraph on
"PROGRAMMING ON – OFF").
NOTE: the machine can be switched on or off
manually as indicated in the previous
paragraph.
1 Small coffee 2 Small coffees
1 Long coffee 2 Long coffees
Continuous Hot Water
Steam Cup Warmer
B
To Next Page
Loading...
