TV Settings
TV Provider Changes &
Channel Auto Scan After Initial Setup
To enter the Channel Menu:
•
Press the MENU button
• Using the t u arrow buttons; scroll to highlight Channel
• Press the down q arrow buttons to highlight Air / Cable
Select Cable if you subscribe to a pay television service without a set top box.
• Press the t u arrow buttons to highlight Cable.
•
NOTE: Channel Auto Scan may take several minutes to complete.
Cable Mode
Air Mode
Select Air when TV is connected to an indoor / outdoor antenna.
• Press the t u arrow button to highlight Air.
•
NOTE: Channel Auto Scan may take several minutes to complete.
satellite set top box to one of the available inputs on the TV for viewing.
Note: For Cable or Satellite users with a set-top box, there is no need to run Channel Auto Scan. Connect your cable
To make changes your TV provider or re-scan for available broadcast channels in your area, select the Channel Menu.
Press the q arrow button to highlight Auto Scan and press ENTER. Press the u arrow button to highlight YES
and press ENTER to begin Auto Scan.
Press the q arrow button to highlight Auto Scan and press ENTER. Press the u arrow button to highlight YES
and press ENTER to begin Auto Scan.
Are you sure to Auto Scan?
No
Yes
Are you sure to Auto Scan?
No
Yes
Total Found : 0
Analog : 0
Digital : 0
RF CH : 2
Next
Channel List
Show/Hide
Channel Number
Channel Label
5-2
KSTP-SD
Total Found : 0
Analog : 0
Digital : 0
RF CH : 2
Favorite
Auto Scan
40V40UHD-29
Cable
Select
Return
Select
Return
To Next Page
Loading...
Need help?
General
