Settings
14
Selecting the time programs (continued) Vitotronic 300-K, MW1S
Changing and scanning the time program for central heating
Time Prog. Central Htg.
1-7
11. Open the hinged cover on the
programming unit.
12. P
ress the heating circuit selector
button; the button is illuminated.
13. Press ; the ”Central
heating time program”
display appears in the
display window.
14. / Press / until one of
the following displays
appears in the display
window:
”1-7” if you wish to set
identical time phases for
all days of the week.
If you wish to exit the time
program setting mode, press
again (see page 14).
Please note:
If different time phases are set for
individual days of the week and
you would like to set the same time
phases for all days again, press
when the display ”1-7” is showing.
All time phases are reset to their
factory settings (see page 4).
Time Prog. Central Htg.
Mo
or
Mo”, ”Tu” etc. if you
wish to set different time
phases for the displayed
day of the week.
15. Press to confirm; the
display changes to ”Central
heating time phase 1”.
Press
to skip a time phase.
16. Press ; the display
changes to ”Central heating
phase 1 ON”.
17. / Press / until the
required starting time of
the central heating phase
appears.
18. Press to confirm; the
display changes to ”Central
heating phase 1 OFF”.
19. / Press / until the
required finishing time of
the central heating phase
appears.
10. Press to confirm; the
display changes to ”Central
heating phase 2 ON”.
11. To set the start and end of central
heating phases “2” to “4”, follow
the procedure described in points 7
to 10.
12. Close the hinged cover on the
programming unit.
After you have confirmed the
finishing timer of central heating
phase 4 with
, the display
changes and shows the boiler
sequence.
5581 751 v1.1
To Next Page
Loading...
