26
You can set time phases for DHW heat-
ing:
■ The DHW cylinder is heated during
the set time phases when using a
boiler with a DHW cylinder connected
to it.
■ If using a boiler with an integral
instantaneous water heater, the DHW
is kept at the set temperature during
the set time phases.
Press the following keys:
01. INFO
02. MODE
03.
Select "SETTINGS" with / .
04. OK to confirm
05. Select "PROGRAMMING" with
/ .
06. OK to confirm
07.
Select "HOT WATER" with / .
08. OK to confirm
09. NEW
Days flash.
10. +/- for the required group of days
or single day
11. OK to confirm
12. +/- for the required set DHW tem-
perature
13. OK to confirm
14. +/- for hour
15. OK to confirm
16. +/- for minute
17. OK to confirm
18. ■ OK to set further switching
times.
■ ESC to exit programming.
Changing or deleting switching times
See page 18.
Temporarily changing the DHW temperature
You can change the DHW temperature
for one hour.
1. Press INFO repeatedly until "HW
SETPOINT TEMP" appears.
2. Select the required set DHW tem-
perature with the rotary selector.
DHW heating
Setting the time program and DHW temperature
5837779
To Next Page
Loading...
Need help?
General
