24
Faults without LED indicator Measures
All indicators on the Vitoconnect
are off.
Check the power supply and the plug-in power supply unit for the Vitoconnect.
Restarting the Vitoconnect
After troubleshooting, the Vitoconnect must be restar-
ted.
Press reset button
B
and operating button
A
simulta-
neously for approx. 15 seconds: See chapter "Display
and controls".
■
LEDs and illuminate green: The starting proce-
dure can take up to 2 minutes.
■
LED illuminates white: The Vitoconnect is ready
for operation.
Restoring factory settings
You can reset all changed values to their factory set-
tings.
1.
Press the reset button
B
for at least 30 seconds:
See chapter "Display and controls".
LED flashes red.
2.
Briefly press reset button
B
again within 5 sec-
onds.
LED is no longer illuminated.
The Vitoconnect restarts.
Setting up the WiFi after replacing the router
1. Enable access point mode for the Vitoconnect: See
page 21.
2. Call up the WiFi settings on your smartphone.
3. Connect your smartphone to the WiFi
"VITOCONNECT-<xxxx>".
4. Enter the WPA2 password.
Note
The WPA2 password can be found on the supplied
label.
5. Go to the internet browser on your smartphone and
open http://vitoconnect.gateway or http://
169.254.11.1
6. On the homepage, choose "Select Router".
7. Follow the instructions on the website.
8. Access point mode is disabled automatically after
5 minutes.
Or
Disable access point mode for the Vitoconnect
manually: See page 21.
What to do if...
Troubleshooting measures (cont.)
5834169
Diagnosis
To Next Page
Loading...
Need help?
General
