Viessmann VITOSOLIC 200 - Scanning messages

7
Actual cylinder temperature curve
Tcylb today
12
Collector temperature curve
Tcol today
12
Amount of heat in kWh
HM 1
7
5 5
33
6
1
Note
The right bar indicates the value of the
current day in kWh.
Scanning messages
Press the following keys:
1. for the "Main menu".
2. for "Reports".
3. OK to confirm.
4. for further displays (see the fol-
lowing table).
"Messages:" Explanation
No fault There is no fault at the solar control unit.
Loading cyl...
(only with several consum-
ers)
Consumer displayed is being heated.
Pause cyl...
(only with several consum-
ers)
Only if the "Cyclical heating" function has been ena-
bled by your heating contractor:
Pause in the heating of the displayed consumer.
Cyl set... Consumer displayed has reached its set value.
Fault A fault has occurred at the solar control unit (for "Scan-
ning the fault display", see page 11).
SW version Software version (only for service engineers)
HW version Hardware version (only for service engineers)
Scanning options
Scanning actual values
(cont.)
5592 613 GB