7
OPERATION
Press it for several seconds again to release this
function, and “LOUD” will disappear.
DISPLAY INFORMATION
Press DISP button (19) to operate as the
conversion of each display mode.
EQUALIZATION
Press EQ button (22) shortly to turn on
equalization function and to select desired audio
mode. There are several kinds of mode as below:
→FLAT→CLASSICS→POP M→ROCK M→DSP OFF
RESET FUNCTION
RESET button (25) must be activated with either
a ballpoint pen or thin metal object. The RESET
button is to be activated for the following reasons:
- Initial installation of the unit when all wiring is
completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (25), the unit
can’t work yet, please use a cotton swab soaked
in isopropyl alcohol to clean the socket on the
front panel.
MODE SELECTION
Shortly press MOD button (5) to select the
desired mode, such as Radio, USB, SD, AUX.
When there isn’t an USB or SD connected to the
unit, the corresponding mode will be skipped.
For Bluetooth function, when pairing successful,
you can select BT or A2DP (Bluetooth audio)
mode through MOD button.
AUXILIARY INPUT
The unit can be connected to a portable audio
player through the AUX IN jack (23) on the front
panel. After finishing the connection, you can
press MOD button (5) on the front panel to switch
the mode to AUX IN mode.
RADIO OPERATION
SELECTING THE FREQUENCY BAND
At radio mode, press BND button (24) shortly to
select the desired band.
The reception band will change in the following
order:
FM1 FM2 FM3 AM (MW)
SELECTING STATION
Shortly press button or button to
activate automatic seek function. Press for
several seconds until “MANUAL” appears on the
display, the manual tuning mode is selected. If
both buttons have not been pressed for several
seconds, they will return to seek tuning mode and
“AUTO” appears on the display then disappears.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press AS/PS button (20) for several seconds
“SEARCH” will appear on LCD. The radio will
search from the current frequency and
checks the signal strength until one cycle
search is finished. And then 6 strongest
stations are stored into the corresponding
preset number button.
- Program scanning
Press AS/PS button (20) shortly to scan
preset station. And the corresponding station
number P1~P6 will flash on LCD.
MONO/STEREO
Press MON button (21) to select mono or stereo
mode. You can sometimes improve reception of
distant stations by selection mono operation.
SCAN
Press SCAN button (18) to enter scan mode, the
unit will scan to higher frequency station and
keep on each station for several seconds (the
corresponding frequency will flash 3 times on
LCD).
STATION STORING
Press any one of the preset buttons (11) (1 to 6)
to select a station, which had been stored in the
memory. Press this button for several seconds to
store the current station into the number button.
RDS (RADIO DATA SYSTEM)
OPERATION
- Setting RDS mode
Press AF/MON button (21) to switch on or off
RDS mode.
- USE PTY BUTTON (17)
Press PTY button (17) will enter PTY SELECT
mode, the program name will be displayed on
the LCD, you can use the volume knob (26) to
select the items and press
/ buttons (1)
to begin search the corresponding program.
To Next Page
Loading...
