EasyManua.ls Logo

ViewSat VS9000HD - (13) SWITCHES

ViewSat VS9000HD
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
(13) SWITCHES:
from left to right:
DISHPRO DPP-44 Switch allows you to pick up to 4 satellite locations and distribute them to up to 4 DISH
Network Receivers. Power inserter included.
• In addition when used with the DP Separator (purchased separately) enables you to run 1 cable into the
home and feed dual tuner DISHPro Receivers (921, 721, 522 and 322) making installations a snap
• Built in DISH Pro Adaptor which will allow this switch to be used with any DISH Network receiver
including older legacy equipment.
DISHPRO DP-34 Switch Works with Dish 300 and Dish 500 satellite systems. Can be used to cascade
additional DP34 multi switches for more receiver outputs. Can only be used with DishPro LNBFs.
• Switch has 3 trunk outputs for cascading to an additional DP34 switch for more outputs
• Can be used indoors or outdoors
• Does not require power insertion / power supply
• Four outputs for connection to up to four DISH Network satellite receivers
ree satellite inputs for use with up to three orbital locations
e first switch in the new DishPro Technology series of LNBFs and switches
DISHPRO DP-21 Switch Two inputs for use with up to three orbital locations - 1 tuner output - Can be
used with a DishPro Twin (or DishPro Quad LNBF) and a DishPro Single LNBF to provide three orbital
locations to one tuner.
• Can be used indoors and outdoors
Does not require power insertion
Zinwell Multi-switch Model SAM4402-3A is designed to distribute 2 Polarizations (usually RHCP and
LHCP or V/H) from 2 satellites to up to 4 IRDs. Polarization selection is by 13V/18V LNB voltage switching.
is unit is powered by the receivers
• Works great with the Channel Master Gain Master dish
• Do not put any Termintators on any input/output ports
• Use this device to hook up four receivers to a two satellite dish (with 4 coax connections) or to two dual-
LNB dishes where each dish is pointed at a separate satellite
Provides signals from two satellites to up to four receivers
NOTE: Problems with Switchers are Connectors, wrong Connection, Power Inserters, Voltage, they
just go bad.
Document page.7
VIEWSAT 9000HD User Troubleshooting Guide & Manual. April /2008

Related product manuals