ViewSonic LDS135-151 - Page 22

22
6. Take the power cord out of the accessory box. Insert the ight plug into the
female socket at the right of the base control box of the screen and rotate the
plug 90° clockwise (as shown below). Ensure the plug is connected securely (a
click should be heard). Insert the other end of the plug into a power socket.
Ensure that the power socket meets the specicaons and standards of the LED
display screen (30A socket for 110V area, and 16A socket for 220V area).

2
7. Aer the power cord is properly connected, the green light and digits on the
control liing plate of the base of the screen will be ON. Press the 2 key (..) on
the control box at the base, or connuously hold the “Up” key, to raise the screen
and li it from the cabinet.
8. Aer the screen is raised to a certain height, pull out the Boom Plate of the
ight case from the front.