4
• Do not place liquids near or on the projector. Liquids spilled into the projector
may cause it to fail. If the projector does become wet, disconnect it from the
power supply and call your local service center to have the projector serviced.
•
•
other. A grounding-type plug has two blades and a third grounding prong. The
outlet.
•
Please ensure grounding prongs are NEVER REMOVED.
•
plug, and at the point where it emerges from the projector.
• In some countries, the voltage is NOT stable. This projector is designed to
operate safely within a voltage between 100 to 240 volts AC, but could fail if
or cut out, it is recommended that you connect your projector through a power
• If smoke, an abnormal noise, or a strange odor is present, immediately switch
using the projector.
•
• Disconnect the power cord from the AC outlet if the projector is not being used
•
CAUTION:
with any bright light source, do not stare into the beam, RG2 IEC 62471-
5:2015.
To Next Page
Loading...
