ViewSonic LX700-4K RGB - Mounting the Projector; Using the Security Bar

19
Mounng the Projector
NOTE: If you buy a third party mount, please use the correct screw size. Screw
size can vary depending on the thickness of the mounng plate.
1. To ensure the most secure installaon, please use a ViewSonic® wall or ceiling
mount.
2. Ensure the screws used to aach the mount to the projector meet the following
specicaons:
• Screw type: M4 x 8
• Maximum Screw Length: 8 mm
3. Place the power adapter within the designated area and secure it with a cable
strap.
82.3 mm
55 mm
55 mm
Security Bar
CAUTION:
• Avoid installing the projector near a heat source or air condioner.
• Keep at least a 10 cm (3.9 in.) gap between the ceiling and the boom of
the projector.
Using the Security Bar
To prevent the projector from being stolen, use a security slot locking device to
secure the projector to a xed object. The security slot can also be used as a safety
anchor if the projector is mounted to the ceiling.