ViewSonic LX700-4K RGB - Page 46

46
Menu Descripon
HDMI CEC
HDMI Link
When you connect HDMI CEC-compable devices to the
projector with HDMI cables, you can control them on the
same power on or power o status using the HDMI CEC
control feature in the projector’s OSD. This lets one device
or mulple devices in a group power on or power o via
HDMI CEC in a typical conguraon.
NOTE:
• In order for the CEC funcon to work properly,
make sure that the device is correctly
connected to the HDMI input of the projector
via an HDMI cable, and its CEC funcon is
turned on.
• If both HDMI 1 and HDMI 2 ports are
occupied, the CEC funcon will not be able to
detect the correct source.
• Depending on the connected device, the CEC
funcon may not work.
XBOX Mode
Enable/disable XBOX CEC funcon.
NOTE: This opon will show up when enabling HDMI
Link. Please connect XBOX via the HDMI 1 port.
Test Paern
Select the test paern from green grid, magenta grid, white
grid, white, test card or disable this funcon (o).
NOTE: To exit Test Paern, set Test Paern to o or
press the Auto Sync key.