ViewSonic M1 VS17337 - Power On;Off; Power On;Off Procedure; Power and Battery Precautions

8
PowerOn/O󰀨
Using power cord
1. Connect the power cord to the power adapter.
2. Connect the AC power cord to a power source
3. Connect the DC power connector to your projector.
Chargetheprojectorfor3hoursbeforeusingitinbatterymodeforthersttime.
IMPORTANT!
• Use only the bundled power adapter to change the battery pack and supply power to your LED projector.
• EnsurethatyourLEDprojectorisconnectedtothepoweradapterbeforeturningitonforthersttime.We
strongly recommend that you use a grounded wall socket while using your LED projector on power adapter
mode.
• The socket outlet must be easily accessible and near your LED projector.
• To disconnect your LED projector from its main power supply, unplug your LED projector from the power
socket.
Warning
Read the following precautions for your LED projector’s battery.
• Thebatteryusedinthisdevicemaypresentariskofreorchemicalburnifremovedordisassembled.
• Followthewarninglabelsforyourpersonalsafety.•Riskofexplosionifbatteryisreplacedbyanincorrect
type.
• Donotdisposeofinre.•Neverattempttoshort-circuityourLEDprojector’sbattery.
• Never attempt to dissemble and reassemble the battery.
• Discontinueusageifleakageisfound.•Thebatteryanditscomponentsmustberecycledordisposedof
properly.
• Keep the battery and other small components away from children,